i.
! WARNING This manual is intended for qualified service personnel only. To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel. ! WARNUNG Die Anleitung ist nur für qualifiziertes Fachpersonal bestimmt. Alle Wartungsarbeiten dürfen nur von qualifiziertem Fachpersonal ausgeführt werden.
For the customers in the USA This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Section 1 Installation 1-1. Overview The i.LINK interface board HKJ-101 enables the Digital Video Cassette Compact Player J-H1/J-H3 to output the down-converted SD video signal in the i.LINK/DV format. In addition, off-line editing can be executed by connecting the J-H1/J-H3 containing the HKJ-101 board to the PC containing the non-linear editing software, using an i.LINK/DV cable. HKJ-101 consists of the followings. . DV-29 board : 1 . CN-2478 board : 1 . Rear panel for J-H1 : 1 .
1-2-1. To install HKJ-101 in J-H1 1. Remove the six M3 case stopper screws. 2. Remove the rear panel. n Store the removed rear panel in a safe place so as not to lose it. 5. Insert the CN-2478 board to the second slot from the bottom of J-H1. 6. Strongly push the connector panel both from the right and the left sides of the CN-2478 board so that the connector on the CN-2478 board is securely inserted into the connector on the MB-993 board.
1-2-2. To install HKJ-101 in J-H3 1. Remove the six M3 case stopper screws. 2. Remove the rear panel. n Store the removed rear panel in a safe place so as not to lose it. Rear panel 4. Insert the connector (CN601) on the DV-29 board into the connector (CN41) on the SDI-80 assembly. n First, insert the connector (CN401) on the DV-29 board to the hole for i.LINK connector on the IF panel. Then insert connector (CN601) to the connector on the CN-2478 board. 5.
. Install the supplied rear panel for J-H3 using the six M3 case stopper screws . n Tighten the screws in the state that the two dowels are aligned with the holes (a) and (b) on the rear panel as shown in the figure.
The material contained in this manual consists of information that is the property of Sony Corporation. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any purpose other than the operation or maintenance of the equipment described in this manual without the express written permission of Sony Corporation. Le matériel contenu dans ce manuel consiste en informations qui sont la propriété de Sony Corporation.
HKJ-101 (SY) J, E 3-805-991-01 Sony Corporation B&P Company Printed in Japan 2003.