Energy Storage System “IJ1001SNBT” Open the energy storage server using screw driver and install the lithium ion battery module Fixing the top cover.
Energy Storage System “IJ1001SNBT” Open the energy storage server using screw driver and install the lithium ion battery module Fixing the top cover.
Energy Storage System “IJ1001SNBT” Set the outer enclosure to the wall 25.4㎜(1in) 177.8㎜(7in) Make a hole for conduit inside the bellow area. 25.4㎜(1in) Hole(1.06in) 304.
Energy Storage System “IJ1001SNBT” Set the outer enclosure to the wall Fixing the outer enclosure to the wall 4 bolts.
Energy Storage System “IJ1001SNBT” Install the energy storage box into the outer enclosure Install the energy storage server to the outer enclosure.
Energy Storage System “IJ1001SNBT” Install the energy storage box into the outer enclosure Wiring 8 position bellow.
Energy Storage System “IJ1001SNBT” Install the energy storage box into the outer enclosure Wiring ground terminal using the grounding cable from outer enclosure to the energy storage server.
Energy Storage System “IJ1001SNBT” Install the energy storage box into the outer enclosure Check the circuit protector.
Energy Storage System “IJ1001SNBT” Install the energy storage box into the outer enclosure Insert the fuse bar.
Energy Storage System “IJ1001SNBT” Install the energy storage box into the outer enclosure Insert the front panel of the server.
Energy Storage System “IJ1001SNBT” Install the energy storage box into the outer enclosure Fixing the jig-3.
Energy Storage System “IJ1001SNBT” Install the energy storage box into the outer enclosure Fixing the jig-4,5.
Energy Storage System “IJ1001SNBT” Assemble the WiFi antenna to the outer enclosure Wear metal parts and fix the metal pipe.
Energy Storage System “IJ1001SNBT” Assemble the WiFi antenna to the outer enclosure Fix the pipe to the outer enclosure.
Energy Storage System “IJ1001SNBT” Assemble the WiFi antenna to the outer enclosure Connect to the antenna cable and fix the cable inside the outer enclosure.
Energy Storage System “IJ1001SNBT” Set the connecting box and conduit Overview Set the connecting box to the wall and conduit from the energy storage system and to distribution panel. Branch circuit inside the distribution panel required UL489 Listed, rated 240Vac, 30A, Time delay. 3 Cables are used, LI(Red) and N(White) connected to 120V, 60Hz. L2(Black) and N connected to 120V, 60Hz. Before start the installation, please refer to the next page.
Energy Storage System “IJ1001SNBT” Set the connecting box and conduit Remarks The field-wiring terminals shall be connected using the following wire types: AC connections: 18 in./lbs. - 22 in./lbs. tightening torque #10 AWG - #14 AWG wire type – rated 90C Copper Equipment Electrode Terminal: 75 in./lbs. – 88 in./lbs. tightening torque #8 AWG - #10 AWG wire type – rated 90C Copper Limits of accuracy of frequency measurement (+ 0.
Energy Storage System “IJ1001SNBT” Set the connecting box and conduit Remarks This charge controller / inverter is intended to charge batteries of the following type 51.2V Li-ion type only. This inverter is intended for operation in an environment having a maximum ambient temperature of 60 degrees C. CAUTION To reduce the risk of fire, connect only to a circuit provided with 30 amperes maximum branch-circuit over current protection in accordance with the National Electrical Code, ANSI/NFPA 70.
Energy Storage System “IJ1001SNBT” Set the connecting box and conduit Conduit work.
