Mini Disc Player User Manual

masterpage:Left
(3 column)
filename[F:\My Document\mds-
s50\4230403131\4230403131\423040313MDSS50U2\GB05OPE-U2.fm]
model name1[MDS-S50]]
[4-230-403-13(1)]
8
Recording to MDs
If the MD has been partially recorded,
recording starts after the recorded tracks.
1 Turn on the amplifier and program
source, and select the source on the
amplifier.
2 Press ?/1 to turn on the deck.
The STANDBY indicator turns off.
3 Load a recordable MD into the slot
(page 16).
4 Press INPUT repeatedly to select the
input jacks (connector) connected to
the program source.
5 If necessary, locate the point on the MD
to start recording from.
If you want to record to a new MD or start
recording from the end of the recorded
portion, skip this step and go to step 6.
To record over from the beginning of an
existing MD track:
Turn AMS (or press
./> repeatedly) until the number of
the track to be recorded over appears.
To record over from the middle of an MD
track:
Turn AMS (or press ./>
repeatedly) until the number of the track to
be recorded over appears, then press NX
(or N)tostartplay.PressNX (or X)at
the point you want to start recording from.
6 Press z.
The deck changes to recording pause.
7 If necessary, adjust the recording level.
For details, see “Adjusting the recording
level” on page 12.
8 Press NX (or press N or X).
Recording starts.
The MD deck is recording over existing
track(s). “Tr” flashes in the display during
recording. The indication stops flashing
when the deck reaches the end of the
recorded portion.
Recording to an MD
When the source is
connected to the
Set INPUT to
DIGITAL OPTICAL IN
connector
D-IN
ANALOG IN jacks A-IN
9 Start playing the program source.
Operations you may want to do
during recording
1) The track number increases by one.
To change the display while
recording
Press LEVEL/DISPLAY/CHAR (or DISPLAY)
repeatedly to change the display.
Each press of the button changes the display
cyclically as follows:
Track number and recorded time of the
current track t Remaining recordable time
2)
on the MD t Level of the input signal t
Track name
3)
2) Time shown in the display differs depending on
the setting of REC MODE.
3) “No Name” appears when the track has no name.
Note
You cannot record over existing material when Shuffle
Play (page 16) or Program Play (page 16) has been
selected. “Impossible” appears in the display at this
time.
To Press
Stop recording x
Pause recording NX (or X)
Resume recording after
pausing
1)
NX (or press N or X)
Eject the MD Z after stopping recording