Dissonant U2 p65 a Hon 1615 a0 |i Notes Doting allow more tha 60 seconds to elapse during the operation procedure. « Ti recording did not suspected, you heat five short error beeps. Start over the ‘procedure. « Cellar comes in while recording » greeting; recording is canceled. Start ‘over the procedure. «TF you hear five short error beeps while recording; the recording ares pay be Ahi Case, erase Necessary messages (see page 71).
Preparing the answering machine (continued) Selecting the ring time You can select the number Of Tings before the answering machine starts to play back the greeting and records incoming messages. There are three ‘options of ring Hume The Sing time is prates to "TOLL SAVER You can set the ring time only with the cordless handset; Make sure the base phone is rot in use before yon start the setting. 1 vices crm.
7 | GIUSOBANG-U2 965 Nate # Do hot allow mire tan §0 seconds to elapse during the operation procedure. » Wu “ERROR” appears on the display and five short error beeps are heard fare fog Dial is pressed in step 4, move the cordless handset closer in the base phone; make sure the base phone is not infuser; and then start uve the procedure. Tip. When you select “(GO BACK)”; Yo tan return to the previous set display by. pressing Jog Dial.
a EE Preparing the answering machine (continued) Notes. # Dona allow more than 40 seconds io elapse during the operation procedure. * The approx, length of the three recording grades are: “HL (SHORT. PLAY)’ 8 testifier. “MID"= 15 minutes NORM (LONG. PLAY) = 20 minutes Actual recording time may Vary.
4 Tarn Jog Dial to choose" ANNOUNCE ONLY” ot “NORMAL”, and then press Jog Dial. You hear a long confirmation beep: Answering mage Heaven you wish 10 Pr-recorded greeting. ANSWERING MODE” play a greeting to ask the taller is set 10 “NORMAL” to leave message. {normal mode) “Heller, I'm unable to answer ‘yous call right now. Please leave: ‘your name; timber and Tillage diet fhe tone.
Preparing the answering machine (continued) When the memory is full The recording area of this phone's memory is about 20 minutes (including the greeting, messages, and memo). If the remaining recording ares becomes less than one minute, te phone symptomatically switches to announcement only mode, which does nol revue dressage, and the greeting will be switched 0 the per-recorded greeting. Confirm the available time left for recording [page 700, * Available Hire for recording at "NORM LONG.
Turning on the answering function Press { ANSWER OFFENSE ) so. that it lights up inured: Notes * When the memory is full, you heat five short error beeps and you cannot fun on the answering Honcho. Erase unnecessary messages (see page 71), I four minutes have passed while recording the incoming message, the ding is mathematically disconnected » It the message is shorter than wo seconds, it will not be recorded.
Playing back messages Yuu can play back messages on both the base phone and the cordless handset, When the phi tie i HF i use and Rot in Announcement only mode, the display of the ‘base phone shows the following “Total number af new messages When you come home ¥ flashes in vod and display on the base ‘phone shows the number of new messages; press MESSAGE PLAY/STOP) on the base phone or on the cordless handset. & The machine plays back from the newest message received.
DIUSIBANS-U2 pis 59: Additional tasks. when playing back messages To Do this ‘Adjust the answering volume During playback, press or (TD) on the baas phone. Thea are? steps fof the answering volume level Adj inst tha cordless handset Set he NOL switch on tha sordidness handset fo. volume H {high}; M {middle or flaw}: Stop playback Press (WESSEX PLACATORY 61 the Base phone or (OEE) on the cordless handset.
Playing back messages {continued} To display of remaining available recording time for message You can see how much recoverable message quantity remains available simply by checking ihe display, The message record able quantity is displayed in 14 levels; Her all 6f the squares on the display are black, it means that the memory is ull, 1. Press (FGM) {If you're at the base phone, press (AEROGRAM) 2 Tum Tog Dial to choose “MEMORY MANAGE", and then press Tog Dial: 3 Tum Jog Dial to choose "REC.
Erasing messages To erase the message one by one Press (ERASE) (ERASE) while the message is being Payed back. You hear a voice guidance and the message is erased. To erase the entire messages at once. Entire message deletion can only be made on the base phone. Note that new messages that have not as yet beer played back will also be erased: 1 Press (PROGRAM; 2 Turn Jog Dial to choose "MEMORY MANAGE”, and then press Jog Dial. 3 Tum Jog Dial to choose “ERASE ALL MSG”, and then press Jog Dial.
Screening incoming calls You can screen calls by leaving the answering function on {see page 67) while you are at home: When a'call is answered; you can hear the message being recorded through the base phone or cordless handset but the caller cannot hear void Then, you can decide whether to answer the call or not. This function is available both the base phone and the cordless handset, However, the following procedures are required in order to screen incoming calls ory the cordless handset.
=H || @Recording a memo You can record 2 “memo” (Upton four minutes) as a personal reminder | raga message for other people. "You narc play back the recorded memo like any incontinent manganese (see page 68). Memo recording is only available on the base phone: 1 Press (MEMO REG. You hear a juice guidance and a long confirmation beep. 2 After the tone; start recording: Speak about 12 inches (30 cm) away from the microphone. 3 Press to stop recording.
co EEE 1 |e 78" Operating from an outside phone “You can call from a touch-tone phone and pick up new. messages recorded on the phone: First, you just set the cremate ID code (security code) and turn on the answering Function before going out. The remote ID code (security code) setting can only be mad ion the cordless handset. Setting the cremate ID code (security code) 1 Press (PERM.
7] 1 Consuelo-UZ pes 5 Picking up new messages Call your phone ior a touchstone phone. 2 while you hear your greeting play, press and your remote TD code (security code): ‘You hear a long confirmation beep and the greeting stops. Following the voice guidance informing you of the number of messages recorded, the phone stands by for you to enter a control code: 3 To-do other operations, enter the control. code within. 20 seconds (see the table below). To quit, hang up the phone.
Caller iD Features TA Understanding the Caller ID service Caller 10) allows the caller's phone number to be shown on the display before you answer the call: In order to use this feature, you inst first subscribe to Caller 1D service: The name of this service may Nagy depending on your telephoned company. To ise this feature, be Sire totterer the area code {see page 17}. When you receive a call The phone number appears on the display as shown the following example.
Looking at the Caller ID list The phone stores the data of the last 70 calls received including “UNKNOWN CALLER” and BLOCKED CALL” calls. It Keeps track of all calls received, even if they were not answered, Viewing the Caller ID list You can look through the Caller ID list on both the base phone‘and the cordless handset to check the phone number and /or name of the calls received. 1 Turn Jog Dill.
Looking at the Caller ID list {continued} Erasing data from the Caller ID list Od data will be erased automatically when a 71st call comes in, but toucan lao manually erase unnecessary data oie By one br erase the ‘entire lst: To erase the phone number one by one 1 Display the hon number you-want to erase from the Caller ID page 77). 2 Press Jog Dial. 3 Turn Jog Dial to choose “ERASE CALLER ID”, and then press Jog Dial. 4 Turn Jog Dial té choose “YES”, and then press Jog Dial.
| To erase the entire list at once Entire Caller 11) list deletion can only be made on the cordless handset: Note that Caller ID data in the list that has not been viewed will lase be erased. 1 Press (PERL. 2 Turn jog Dial to choose "MEMORY (50 BACK) MANAGE", and thee press Jog Thai: REC. CAPACITY $SEND ALL-DIR 3 Turn Jog Dial to choose "ERASE ALL CID”, and then press Jog Dial.
Using the Caller ID list By.using the Caller ID list, you can call back a phone number from the Caller ID list easily, play back messages, or store numbers from tha Caller ID list into the Phone Directory, Calling back a number from the Caller iD list 1 Display the phone bummer you want to call from the Caller ID list {see page 77). SMITH JOHN 01 7.04: 4.53PM _ 2 Press Jog Dial. (60 BACK) ; Dial ® ~|3BLAY BACK 3 Turn Jog Dial to choose “DIAL”, and then press Jog Dial.