Manual

Warning messages
Message
High temp.! Lamp oil' in 1
rnin.
Frequeucy is out of range !
Please check lnput-A -)
Signal Sel.
Please replace the Lamp/ -)
Filter. -)
Please replace the filter. -)
Please replace the filter. -)
Have you lhfished? Yes No
-)
Projector temperature is +
high. Cooling Setting
should be "High" if +
projector is being used at
high altitude.
Cause and Remedy
+ Turn o11"the power.
-) Check to ensure that nothing is blocking the ventilation holes.
((_" page 13)
-) Frequency is out of range, lnput a signal that is within the
acceptable li'equency range of the projector.
Sel "lnpuI-A Signal Sel." in the Setup _ menu to
"Computer" when an RGB signal is input fi'om a computer.
((_" page 47)
It is time to replace the lamp. Replace the lamp. ((_ page 55)
Also, replace the air" l]lter too. Restart cleaning the Ventilation
holes (intake). ((_" page 55)
If this message appears agaiu after you replace the lamp and
filter, the lamp replacement process is uot complete. Check the
lamp replacement process. ((_ page 55)
To clear this message, press any buttou either ou the remote control
or the control panel of the pn_iector once.
It is time to replace the air"l]lter. Replace the air filter. ((_ page
58)
It is time to replace the air l]lter. Replace the air filter. ((_ page
58)
If you replaced the air filter, select "Yes." If you did not replace
the air filter, select "No?'
Check to ensure that the Ventilation holes on the unit are not
covered. ((_" page 13)
When using the projector at high altitude, set the (ooling
Setting to "High". ((_ page 46)
When temperature inside the projector remains high, the Cooling
Setting is switched to "High" in I minute, then the f:m speed
increases.
Caution messages
Message Cause and Remedy
x@ + No signal is input in the selecled ir'q_ul. Check conneclious.
((_ page 17)
Not applicable! + Press the appropriate button.
The operation to be activated by the button is currently
prohibited.
54