- SONY Data Projector Operating Instruction

14
Turning Off the Power
Turning Off the
Power
1 Press the ?/1 key.
“POWER OFF? Please press ?/1 key
again.” appears to confirm that you want
to turn off the power.
The message disappears if you press any
key other than the ?/1 key, or if you do not
press any key for five seconds.
2 Press the ?/1 key again.
The powered tilt adjuster is retracted
into the projector. The ON/STANDBY
indicator flashes in green and the fan
continues to run to reduce the internal
heat. Also, the ON/STANDBY indicator
flashes quickly for the first 45 seconds.
During this time, you will not be able to
light up the ON/STANDBY indicator
again with the ?/1 key.
3 Unplug the AC power cord from the
wall outlet after the fan stops running
and the ON/STANDBY indicator
lights in red.
When you cannot confirm the on-
screen message
When you cannot confirm the on-screen
message under certain conditions, you can
turn off the power by holding the ?/1 key for
about two seconds instead of above steps 1
and 2.
The internal circuitry of the Off & Go function
may cause the fan to continue to operate for a
short time even after the ?/1 key is pressed to
turn off the power and the ON/STANDBY
indicator changes to red.
Note
Note