Operation Manual

9
Connecting the Projector
Projecting the Picture
Connecting the
Projector
When you connect the projector,
make sure to:
• Turn off all equipment before making any
connections.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; loose
connections may increase noise and
reduce performance of picture signals.
When pulling out a cable, be sure to pull it
out by the plug, not the cable itself.
This section describes how to connect the
projector to a computer.
For more information, refer to the
computer’s instruction manual.
To connect a computer
A HD D-sub 15-pin cable (supplied)
B A/V connecting adaptor (supplied)
C Audio cable (not supplied) (Connect only
when you want to output the audio from the
speaker of the projector.)
• The projector accepts VGA, SVGA, XGA,
SXGA, and SXGA+ signals. However, we
recommend that you set the output mode of
your computer to XGA (VPL-CX21) or
Connecting a Computer
Notes
Left side
to monitor
output
Computer
White
to audio
output
(L)
Red
to audio
output
(R)