Operation Manual

54
Specifications
high impedance, positive/
negative
AUDIO: Stereo minijack rated
input 500 mVrms, input
impedance 47 kilohms
INPUT B Analog RGB: HD D-sub 15-pin
(female)
R: 0.7 Vp-p ±2 dB (75 ohms
terminated)
G: 0.7 Vp-p ±2 dB (75 ohms
terminated)
B: 0.7 Vp-p ±2 dB (75 ohms
terminated)
HD: Horizontal sync input: TTL
level high impedance, positive/
negative
VD: Vertical sync input: TTL
level high impedance, positive/
negative
AUDIO: Stereo minijack, rated
input 500 mVrms, input
impedance more than 47
kilohms
INPUT C NETWORK (VPL-CX125/CX155
only)
RJ-45: 10BASE-T/100BASE-
TX
OUTPUT MONITOR OUT’: HD D-sub 15-
pin (female)
R, G, B: Gain Unity: 75 ohms
SYNC/HD, VD: 4 Vp-p (open),
1 Vp-p (75 ohms)
AUDIO OUT (variable out):
Stereo minijack
1 Vrms (When the volume is
maximum and an input signal is
500 mVrms), output impedance
5 kilohms
REMOTE RS-232C: D-sub 9 pin
General
Dimensions 372 × 90 × 298 mm (14
3
/
4
× 3
5
/
8
× 11
3
/
4
inches) (w/h/d)
(without the projection parts)
Mass Approx. 4.1 kg (9 lb 1 oz)
Power requirements
AC 100 to 240 V, 2.9 - 1.2 A,
50/60 Hz
Power consumption
Max. 285 W
(in standby (standard): 7 W in
standby (low): 0.5 W)
Heat dissipation
973 BTU
Operating temperature
0°C to 35°C (32°F to 95°F)
Operating humidity
35% to 85% (no condensation)
Storage temperature
–20°C to +60°C (–4°F to +140°F)
Storage humidity
10% to 90%
Supplied accessories
Remote Commander (1)
Size AA (R6) batteries (2) (VPL-
CX125/CX155)
Lithium battery CR2025 (1) (VPL-
CX100/CX120/CX150)
Lens cap (1)
HD D-sub 15 pin cable (2 m) (1)
(1-791-992-xx)
AC power cord (1)
CD-ROM (Operating Instructions,
Application Software) (1)
Quick Reference Manual (1)
Safety Regulations (1)
Security Label (1)
Design and specifications are subject to change
without notice.
Always verify that the unit is operating properly
before use. SONY WILL NOT BE LIABLE FOR
DAMAGES OF ANY KIND INCLUDING, BUT
NOT LIMITED TO, COMPENSATION OR
REIMBURSEMENT ON ACCOUNT OF THE
LOSS OF PRESENT OR PROSPECTIVE
PROFITS DUE TO FAILURE OF THIS UNIT,
EITHER DURING THE WARRANTY PERIOD
OR AFTER EXPIRATION OF THE
WARRANTY, OR FOR ANY OTHER REASON
WHATSOEVER.
Optional accessories
Projector Lamp
LMP-C200 (for replacement)
Presentation Tool
RM-PJPK1
Note