Operating Instructions Data Projector VPL-CX155/CX125, VPL-CW125

26
Others
PC: Message displayed on the computer
PJ: Message displayed on the projector
Messages on the Display
Message PC PJ Cause and Remedy
Now searching LAN
Module.
a
• The connectable LAN module within the PC is being
searched according to the priorities of the LAN modules
specified in the [Option Setting] window.
c If the message persists, check and set the LAN module
to be used in [Basic Setting] of the [Option Setting]
window.
Waiting until the IP
address is set.
a
• The Projector Station for Air Shot Version 2 is waiting
for the IP address to be set for the LAN module.
c If this message persists, check the wireless and network
settings for the LAN module you use. If the
Auto(DHCP) is selected, it may take few minutes to set
the IP address.
No connectable Projector
has been found.
a
• The Projector Station for Air Shot Version 2
communications are blocked because of the Firewall.
c See the “Troubleshooting” on page 24.
• The network setting of the projector is not identical with
those of the computer.
c Check and re-set the network setting for both the
projector and computer.
• The network segment (subnet) of the computer and the
projector are different.
c Set the PC Registration List (page 10) on the projector
and [Projector Setting] window (page 18) on the
computer.
• Wireless transmission conditions are extremely poor
when the wireless network is used for the computer.
c Place the computer close to the access point, or remove
the obstacles between the access point and computer.
• Network conditions are poor.
c Contact your network administrator.
Network communication
error.
a
• The computer is unable to perform proper network
communications.
c Restart Windows and start Projector Station for Air
Shot Version 2.
c Check the setting of the USB wireless LAN module
used in the Projector Station for Air Shot Version 2.
Projector communication
password error.
a
• The password specified with the projector is not
identical with those specified with the computer.
c Set the same password to the computer as the projector
in the [Profile Setting] of the [Option Setting] dialog
box.