Operation Manual

13
GB
Start-up Guide
If a message appears for you to confirm
the aerial connection
No digital or analogue channels were
found. Check all the aerial/cable
connection and then press to start auto-
tuning again.
8 When the “Programme Sorting” menu
appears on the screen, follow the steps of
“Programme Sorting” (page 36).
If you do not change the order in which
the analogue channels are stored on the
TV, press RETURN to go to step 9.
9
For details, see page 32.
10
For details, see page 28.
11 Press .
The TV has now tuned in all the available
channels.
~
• When a digital broadcast channel cannot be
received, or when selecting a country in which
there are no digital broadcasts in step 4, the time
must be set after performing step 8.
• XEL-1 screen saver may appear if no operation is
performed for a few minutes.
To tune the TV for cable connection
1 Press .
2 Press V/v to select “Quick Scan” or “Full
Scan”, then press .
“Quick Scan”: channels are tuned
according to the cable provider
information within the broadcast signal.
This option is recommended for fast
tuning when supported by your cable
provider.
If the “Quick Scan” does not tune, please
use the “Full Scan” method below.
“Full Scan”: all available channels are
tuned and stored. This procedure may take
some time.
This option is recommended when “Quick
Scan” is not supported by your cable
provider.
For further information about supported
cable providers, refer to support web site:
http://support.sony-europe.com/TV/
DVBC/
3 Press v to select “Start”, then press .
The TV starts searching for channels. Do
not press any buttons on the TV or
remote.
~
• Some cable providers do not support “Quick
Scan”. If no channels are detected using “Quick
Scan”, perform “Full Scan”.
• XEL-1 screen saver may appear if no operation is
performed for a few minutes.
Quick Start
Yes No
Do you want to enable Quick Start?
TV turns on more quickly but standby power consumption is increased.
Control for HDMI
Yes No
Do you want to enable control for compatible
HDMI devices?