FM/AM Cassette Stereo Installation/Connections Installation/Connexions XR- 1100 Sony Corporation © 2000 Car
Parts for installation and connections The numbers in the list correspond to those in the instructions. @ ® @ ® ® ® x2 ® @ ×4 Caution Cautionary notice for handling the bracket (D. Handle the bracket carefully to avoid injuring your fingers. Note The tool (_ is used for removing the unit. Be sure to keep it for future use.
Connections Caution • • • • This unit is designed for negative ground 12 V DC operation only. Before making connections, disconnect the ground terminal of the car battery to avoid short circuits. Connect the yellow and red power input leads only after all other leads have been connected. Be sure to connect the red power input lead to the positive 12 V power terminal which is energized when the ignition key is in the accessory position. * Run all ground wires to a common ground point.
Speaker connections, White C Front speakers Gray I Gris _*_ _ Right XR-1100 L O: Striped cord Left Green Rear speakers Haut-parleurs arri_re Vert Purple j °" Right Notes on speaker connection • Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Otherwise, the speakers may be damaged. • Do not connect the terminals of the speaker system to the car chassis,and do not connect the terminals of the right speaker with those of the left speaker.
Connection example, XR-1100 from a car antenna to the +12 V power terminal which is energized In the accessory position of the ignition key switch. Be sure to connect the black earth lead to it first. Red to the +12 V power energized terminal which is at all times. Be first.sure to connect the black earth lead _ | _ Yellow Front speakers Reerspeake_ Notes on the control leads • The power antenna control lead (blue) supplies 12V DC when you turn on the unit.
-1100 Fuse (10 A) to the power antenna supply lead of antenna Notes control booster lead or power amplifier • It is not necessary to connect this lead if there is no power antenna or antenna booster, or with a manually-operated telescopic antenna, • When your car has a built-in FM/AM antenna in the rear/side glass, see _Notes on the control leads. _ Blue I ANT REM Max. supply current 0.
I Removing the unit 1 Insert the supplied tool _) between the unit and the frame, and rotategO ° to release the hidden mounting spring. Repeat on the opposite side and remove the frame. 2 Insert a flathead screwdriver between the bracket and mounting spring. Gently pry the spring toward the unit while pulling the unit out a little. Repeat on the opposite side and remove the unit.
2 4 mm (3/,6 In./po.
Installation Precautions • Choose the installing location carefully so that the unit will not interfere with driving. • Avoid installing the unit where it would be subject to high temperatures, such as direct sunlight or hot air from the heater, or where it would be subject to dust, dirt, or excessive vibration. • Use only the supplied mounting safe and secure installation. hardware Mounting angle adjustment Adjust the mounting angle to less than 20 °.
Installation 3 Bend these clews, if necessary.
4 5 ® Mounting the unit in a Japanese car This unit may not be installed in some makes of cars. In this case, consult your nearest Sony dealer. TOYOTA NISSAN to dashboard/center console au tableau de bord/console centrale (_) max. size _5 x 8 mm Dimension max. e5×8mm (_) max. size e5 x 8 mm Dimension max. oSx8mm Bracket Suppo_ Note To prevent malfunction, install only with the supplied screws _).
I To support the unit Fire wall Dashboard NISSAN to dashboard/centerconsole (_ max, size 05 × B mm (_ ma)_ size e5 x B mm Bracket
Sony Corporation Printed in USA
