User's Manual

HD1BT

INSTALLATION

Before you Begin

1. Disconnect Battery

Before you begin, always disconnect the battery negative terminal.

2. Remove Transport Screws

Important Notes

 Before final installation, test the wiring connections to make sure the unit is connected

properly and the system works.

 Consult with your nearest dealer if installation requires the drilling of holes or other

modifications to your vehicle.

 Install the unit where it does not interfere with driving and cannot injure passengers during

a sudden or emergency stop.

 If the installation angle exceeds 30° from horizontal, the unit might not give optimum

performance.

 Avoid installing the unit where it will be subjected to high temperatures from direct sunlight,

hot air, or from a heater, or subject to excessive dust, dirt or vibration.

Installation Method

NOTE: Use existing factory side brackets and hardware to mount the radio.

1. Place the radio in front of the dashboard opening so the wiring can be brought through the

opening

2. Follow the wiring diagram carefully and make certain all connections are secure and

insulated with crimp connectors to ensure proper operation. In typical factory replacement,

you will simply connect the 23 pin black connector from the motorcycle into the radio.

3. After completing the wiring connections, turn the unit on to confirm operation (vehicle

accessory switch must be on). If the unit does not operate, recheck all wiring until the

problem is corrected. Once proper operation is achieved, turn the accessory switch off

and proceed with final mounting of the chassis.

4. Ensure that the unit is supported and secured on the sides and rear, failure to do so may

allow the unit to move during while riding, causing damage to the mounting area.

5. Test radio operation by referring to the operating instructions for the unit.

Removing the Unit

To remove the radio after installation, remove mounting hardware securing unit to the vehicle

and then pull the radio out.

Reconnect Battery

When wiring is complete, reconnect the battery negative terminal.