User's Manual

e.g. Set the Station Without Control Points

1. Setup the Navi Station at an unknown point,

called P1, then get the coordinate of P1 by GNSS.

2. Select P1 as the first station (STN). Aim at the

second unknown point P2 as backsight (BS Pt)

3. Finish the measurement under STN P1.

4. Setup the Navi Station at the second unknown

point P2, then get the coordinate of P2 by GNSS.

5. Use P1 as backsight (BS Pt). Navi Station will re-

calculate coordinate & azimuth between P1 and

P2.

6. Use Reduction (Refers to Chapter 8.1

Reduction) to re-calculate the coordinate of

points which has been measured under STN P1.

7. Finish the measurement under STN P2.

Please refers to Chapter 5.1 for further

information.