Quick Start Guide

MULTI-cast Mode:
Connecting Multiple Speakers Together
Enable Multi-cast Mode for Speakers
1. Choose a speaker and connect to it via Bluetooth. (This will be the ‘Primary’ speaker.)
2. Next, press and hold the UP button until you hear “broadcast mode enabled”. The right LED light on the
keypad will begin toblink.
3. Turn ON another DB1 or DB2 speaker. (This speaker will be a ‘Satellite’ speaker.)
4. On the second speaker, press and hold the DOWN button until you hear “broadcast audio enabled”.
Both speakers are now ENABLED for multi-cast mode, and ready for pairing.
5. To activate multi-cast pairing, quick press both the UP and DOWN volume buttons on the Primary
speaker at the same time. Repeat this action on the Satellite speaker.
a. The Primary DemerBox LEDs will start a back and forth tracking pattern.
b. The Satellite DemerBox LEDs will alternate in a LEFT / RIGHT pattern.
c. After a few seconds you should hear “paired.” You are now ready to listen to both speakers.
Exiting Multi-cast Mode
To exit multi-cast mode, hold down the UP/DOWN volume buttons for 5 seconds. You can also turn the
speaker OFF/ON .
Volume Control
When in multi-cast mode, the Primary speaker volume buttons control the volume on all paired speakers. You can
also use the volume control on your device.
add an additional speaker
Once the boxes are in multi-cast pairing mode, they will stay active for 30 seconds. You maybe able to connect
several more speakers to the Primary during this time. (You will know if the speakers are active if they display the
LED patterns described in 5a, 5b above).
If you are adding another speaker more than 30 seconds after initial Primary and Satellite pairing,
repeat steps 3-5c.