Use and Care Manual

Assembly (Continued)

• Save all instructions

Attach upper handle (See Figure 6,7)

1. Slide the upper handle down over the lower handle and

align the holes. Orient upper handle so clutch lever is

below handle.

2. Insert the saddle bolts into the holes as shown and

secure with at washers and handle knobs.

3. Tighten the handle knobs securely.

4. Using one cable tie, secure the control cable to

the handle as shown.

Install the outside tine shields (See Figure 8)

1. Each outside tine shield can be installed on either side

of the main tine shield.

2. Place the outside tine shield underneath the main tine

shield and align the holes.

3. Secure each outside tine shield to the main tine shield

with (3) M6 x 16 bolts washers and lock nuts.

Install the rope guide (See Figure 9)

1. Install the rope guide into the right hand section of

the upper handle as shown. Install locknut and tighten

securely. Pull engine rope and route through

the guide.

Figure 7

Figure 8

Figure 9

Figure 6

Saddle

Bolts

Handle

Knobs