Use and Care Manual
ENG - 18Questions? Call Toll Free at 1-800-737-2112 Copyright © 2018 MAT Engine Technologies, LLC
How to Prepare for Storage
E
WARNING
Never store the tiller indoors with fuel in the fuel tank.
Never store in an enclosed, poorly ventilated area where
fumes could reach an open ame, a spark or a pilot light as
on a furnace, water heater or clothes dryer. Allow engine to
cool before storing unit.
WARNING
Do not remove gasoline while inside a building, near a re,
or while you smoke. Gasoline fumes can cause an explo-
sion or a re.
NOTE: A yearly checkup or tune-up at an authorized service
center will make sure that the tiller will provide maximum
performance for the next season.
When the tiller is put in storage for thirty days or more, the
following steps should be followed to make sure the tiller is in
good condition the next season. To prevent fuel gum deposits
and corrosion in the unit’s carburetor and fuel system, it is
highly recommended to use a fuel additive/stabilizer formulated
for ethanol fuels. Follow the stabilizer manufacturer’s
instructions. Run the engine for at least 5 minutes after adding
stabilizer.
1. Let the engine run until it is out of gasoline. Remove
carburetor screw from bowl and drain fuel. Tilt unit
slightly to remove all fuel. Replace screw. (Figure 19)
2. Change the oil by following instructions under “How to
Change the Oil.”
3. Remove the spark plug from the cylinder. Pour one
ounce (1 oz liq. US / 30 ml) of oil into the cylinder.
Slowly pull the recoil-start handle so that the oil will
protect the cylinder. Install a new spark plug in the
cylinder. Pull starter handle slowly a few times to
Maintenance (Continued)
• Save all instructions
You may have further questions about assembling, operating, or maintaining this TILLER. If so, you can contact our
Technical Service Department at 1-800-737-2112 (English only).
You may also write to:
METL Corporate Office - CORRESPONDENCE ONLY
ATTN: Technical Service – METL
6700 Wildlife Way
Long Grove, IL 60047
Technical Service
When contacting the Technical Service Department, have ready:
• Your Name
• Your Address
• Date Code on Product
• Your Phone Number
If you need assistance or have any questions, CALL
TOLL FREE: 1-800-737-2112.
distribute oil. Pull recoil handle slowly until resistance is
felt. This will close the cylinder valves.
WARNING
DO NOT attach spark plug wire to spark plug when
storing unit.
4. Clean tiller. Remove all dirt, leaves, debris, grease, etc.
from the tiller - including cylinder cooling fans, recoil
starter cover holes, under fuel tank, and under mufer.
5. Check the tiller for worn or damaged parts. Have
damaged parts replaced if necessary.
6. Tighten any loose hardware.
7. Apply lubrication as directed in Maintenance section.
8. Put the unit in a building that has good ventilation.
9. Cover the tiller with a breathing material.
Figure 19
Remove carburetor screw from
bowl and drain fuel. Replace screw.