Use and Care Manual

ManualsBrandsSouthland ManualsOutdoor Power Equipment11 in. 150cc Gas Front-Tine Tiller

The tiller comes assembled except for a few parts. The

following instructions will help you complete the tiller assembly.

Attach the wheel assembly to the frame

1. Install the wheel assembly to the frame by removing

a hairpin cotter and at washer from one end of pivot

rod. Remove rod from frame. Align pivot holes in

wheel assembly to pivot holes in frame. Install pivot rod

and secure by reinstalling at washer and hairpin.

(See Figure 2)

Assembly

• Save all instructions

If you need assistance or find any parts missing,

CALL TOLL FREE: 1-800-737-2112.

Read and follow the assembly instructions. Do not discard

any parts or materials until the unit is assembled.

References to the right or left side of the tiller are from the

viewpoint of the operator’s position behind the tiller.

WARNING

Do not operate tiller if it is damaged or not completely and

correctly assembled.

WARNING

Before doing any assembly or maintenance to the unit,

remove the wire from the spark plug.

WARNING

Always wear ANSI compliant safety glasses with side

shields while assembling the tiller.

The following components will be found in the carton.

Quantities shown in ( ).

1. (1) Tiller

2. (1) Upper Handle Assembly

3. (1) Lower Handle

4. (4) Tines

5. (1) Wheel Assembly

6. (1) Drag bar

7. (2) Outside Tine Shields

8. (1) Tiller Operator’s Manual

9. (1) Engine Manual

10. (1) Bottle of Engine Oil

11. (1) Parts bag containing the following

a. (4) M10 x 25 mm bolts, flat washers and lock washers

for assembling lower handle.

b. (4) M8 x 25 mm saddle bolts and flat washers for as-

sembling upper handle to lower handle.

c. (4) Handle knobs, for upper handle to lower handle.

d. (2) Lynch pins for assembling outer tines.

e. (2) M10 x 50 mm bolts, (4) flat washers and (2) M10

locknuts for assembling inner tines.

f. (1) Pin, flat washer and hairpin cotter for drag bar.

g. (6) M6 x 16 bolts, lock nuts, and flat washers for install-

ing outside tine shields.

h. (1) Rope guide with nylock nut.

i. (1) Cable Ties.

1. Remove all parts and packaging components.

2. Use a utility knife to cut all 4 vertical edges and lay the

side panels flat around the tiller.

3. Remove any remaining packaging.

How to Remove Tiller from Carton

Assembly Instructions

Figure 2