Instructions / Assembly

The newest innovation

for pulling wire!

In today’s high tech world there is a lot of cable

being pulled above drop ceilings, and that cable

is fragile and expensive. Snagging cables on the

drop ceiling not only ruins the cable but also the

ceiling, creating delays and extra costs. That is all

a thing of the past with Madison’s new Stingray.

Simply remove the ceiling tiles and snap the

Stingray into the corner of the drop ceiling.

That’s it! You now have a safe and effective

chase to run your cables through any drop

ceiling. When you’re ﬁnished simply pull the

Stingray’s tail and slide it off the grid.

• Protects expensive and fragile cables

• Protects ceiling from twisting and marring

• Smooth interior for an almost frictionless chase

• Side slit allows for easy cable removal

• Fits 1" standard ceiling grid

• Easy to install and remove

Madison Electric Products, Inc. 26401 Fargo Avenue • Bedford Heights, OH 44146 • P: 1-800-631-7775

PROTECTS THE GRID. PROTECTS THE CABLES.

INSTRUCTIONS FOR USE

1 2 3

1. Remove both tiles in the corner of

the ceiling you wish to install the

Stingray, and position the Stingray tail

down as shown.

2. Slide Stingray into the corner of the

ceiling grid, positioning the upper ﬁns

above the grid, and the lower ﬁns

below the grid.

3. With the ceiling grid slotted between

the Stingray’s ﬁns, push until Stingray

locks into corner. You are now ready to

run your wire.

TO REMOVE: Simply pull the Stingray’s tail to release from ceiling grid and slide off.