User guide

INSTALLATION INSTRUCTIONS - LED COMPACT WALL SCONCE SHEET 3 OF 3
SAVE THESE INSTRUCTIONS
701 Millennium Boulevard Greenville, SC 29607 [phone]
NOTES:
For replacement LED Assemblies and Drivers please contact Hubbell Lighting for any replacement parts.
Contact your local distributor or agent to confirm parts availability prior to ordering replacement parts.
IMPORTANT: To weatherproof your outdoor installation, be sure to seal all housing (Mounting, Conduit,
Plugs, etc.) with silicone sealant.
INSTALLATION:
6.Locate the “THIS END UP” label on the back of the unit as a reference for the following steps.
7.Install the provided self-adhesive gasket to the back of the mounting plate (1). Install the mounting
plate (1) on the junction box (Fig1) with screws.
8.Use approved connectors to connect fixture leads to supply leads. Place splices inside the junction
box.
9.Put the fixture on the mounting plate (1), and tighten retaining screws (2), use Silicone around housing
except the bottom of the fixture.
TROUBLE SHOOTER-CHECK LIST
IF LIGHT DOES NOT WORK:
1.Check Your Power Source.
2.Check Electrical Connections.
Figure 1
Figure 2
http://www.spauldinglighting.com