Link Wireless Telephone System Installation and Operation Link 150 M3 MCU
Table Of Contents
- About This Document
- Installation Overview
- Link Wireless Telephone System Overview
- Site Preparation
- Run Cable for System
- Install Link Wireless Telephone System
- Connect and Register Handsets
- Site Certification
- System Administration
- Link Wireless Telephone Planning Worksheet
- Base Station Location Worksheet
- Technical Parameters
SpectraLink Corporation Installation and Operation
Link WTS – Link 150 M3 MCU
9.6 Replace a Base Station
To replace a Base Station, unplug the existing Base Station and plug in the new Base
Station.
• The LED will blink red and green as the system software downloads to the Base
Station and the Base Station is tested.
• When the LED blinks amber, the system is ready for operation.
• When the LED blinks green, a handset has established a radio link with that Base
Station.
• If the LED turns solid red, there should be an error message on the MCU’s
STATUS LEDs and the MCU ERROR LED should be lit.
PN: 72-0075-01-F.doc Page 41