Manual

Spectrex Inc. - SharpEye

UV/IR Flame Detector Manual –

TM20/20LB Rev E, August 2004

2. Wiring

Refer to Fig. 10.

1 Disconnect power.

2 Release the four (4) slotted-head screws (Item 3) that secure the chamber

cover (Item 2). The chamber is now revealed.

3 Remove the protective plug mounted on the detector conduit inlet, pull the

wires through the detector chamber (Item 7). Use M25x1.5 explosion-proof

conduit connection to assemble the conduit to the detector.

4 Connect the wires to the required terminals (Item 4) according to the wiring

diagram. See paragraph 2.1 and figures no. 11 and no. 12.

5 Connect the grounding wire to the ground screw outside the detector cover

(Item 5).

The detector must be well grounded to Earth Ground for proper

operation.

6 Verify the wiring. Improper wiring may damage the detector.

7 Check the wires for secure mechanical connection and press them neatly

against the terminal to prevent them from interfering while closing the cover

(Item 2).

8 Place and secure the cover chamber (Item 2) using four (4) slotted-head

screws (Item 3).