Owner manual

Chapter 3: Configuring the 1762sc-OF8 for RSLogix 500 3-3
User’s Manual Pub. 0300246-01 Rev. B
5.) Repeat steps 1 through 4 for additional modules.
Section 3.4
Module
Configuration
The OF8 module is configured using a process that employs the input and output files.
The following flow chart describes the configuration process.
Note: Each command issued will have a corresponding module response
in the input data file. See Section 3.5.1 for more information.
Note: For proper operation, during the 600 ms delay, the output words
should be set to the correct command values to avoid sending erroneous
analog signals.
Transition
To
Run
Unlock
Command
Issued
Write
Configuration
Data
Issue Load
Configuration
Command
Issue
Exit
Command
600 ms
Delay
Module
Enters Run
Mode