Owner manual

Micro800™ 4 Ch Universal Thermistor Input Module 27
Publication 0100198-01 Rev. A
Safety
Tests
Industry Standards
Test Level
Limits
UL Safety
UL 508 Industrial Control Equipment
Seventeenth Edition Dated January 28
1999, with revisions through July 11, 2005
(ANSI/UL 508-2005) (NRAQ, NRAQ7)
cUL CSA C22.2 No. 142 -M1987 Process
Control Equipment May 1987
UL Safety
UL
Hazardous
Locations
ULH ANSI/ISA–12.12.01–2007
Nonincendive Electrical Equipment for Use
in Class I, Division 2 Hazardous (Classified)
Locations T4 or better
cULH CSA C22.2 No. 213-M1987 - Non-
incendive Electrical Equipment for use in
Class I Division 2 Hazardous Locations -
March 1987
UL Hazardous
Locations
CE Low
Voltage
Directive
IEC 61131-2 Programmable Controllers
Part 2: Equipment Requirements and Tests;
Second Edition 2003-02, Section 11-14
CE Low
Voltage
Directive
Hazardous Location Considerations
This equipment is suitable for use in Class I, Division 2, Groups A, B, C,
D or non-hazardous locations only. The following WARNING statement
applies to use in hazardous locations.
WARNING
EXPLOSION HAZARD
 Substitution of components may impair
suitability for Class I, Division 2.
 Do not replace components or disconnect
equipment unless power has been
switched off or the area is known to be
non-hazardous.
 Do not disconnect equipment while the
circuit is live or unless the area is known
to be free of ignitable concentrations.
 This product must be installed in an
enclosure which can only be opened with
the use of a tool.
 All wiring must comply with N.E.C. article
501-4(b).