Warranty

5
• Tool service must be performed only by qualified repair personnel.
• When servicing a tool, use only identical replacement parts. Use only authorized parts.
• Use only the lubricants supplied with the tool or specified by the manufacturer.
• Never connect to an air source that is capable of exceeding 200 PSI. Over pressurizing
the tool may cause bursting, abnormal operation, breakage of the tool, or serious injury.
Use only clean, dry, regulated compressed air at the rated pressure or within the rated
pressure range as marked on the tool. Always verify prior to using the tool that the air
source has been adjusted to the rated air pressure or within the rated air-pressure range.
• Never use oxygen, carbon dioxide, combustible gases, or any bottled gas as an air
source for the tool. Such gases are capable of explosion and serious injury.
Important Operating Instructions
GENERAL SAFETY INSTRUCTIONS
• The warnings and precautions discussed in this manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this product, but must
be supplied by the operator.
• Only use accessories rated to handle the forces exerted by this tool during operation.
Other accessories not designed for the forces generated may break and forcefully launch
pieces.
• Attach all accessories properly to the tool before connecting the air supply. A loose
accessory may detach or break during operation.
• Obey the manual for the air compressor used to power this tool.
• Install an in-line shutoff valve to allow immediate control over the air supply in an
emergency, even if a hose is ruptured.
• Use this tool with both hands only. Using tools with only one hand can result in loss of
control.
• Do not lay the tool down until it has come to a complete stop. Moving parts can grab the
surface and pull the tool out of your control.
SPECIFIC SAFETY INSTRUCTIONS