2.
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit horizonhobby.com or towerhobbies.com and click on the support or resources tab for this product.
EN INSTALLING THE TRANSMITTER BATTERIES This transmitter requires 4 AA batteries. 1. Remove the battery cover from the transmitter. 2. Install the batteries as shown. 3. Install the battery cover. CAUTION: If using rechargeable batteries, charge only rechargeable batteries. Charging non-rechargeable batteries may cause the batteries to burst, resulting in injury to persons and/or damage to property. CAUTION: Risk of explosion if battery is replaced by an incorrect type.
EN SR315 RECEIVER Specifications Type: DSMR® (DSM2® compatible) Dimensions (LxWxH): 32.5mm× 21.5mm × 13.4mm Antenna Length: 3.5 in (90mm) Channels: 3 Weight: 6g Band: 2.4GHz (2404 MHz – 2476 MHz) Voltage Range: 3.5–9.6V Steering Throttle Aux 1 Battery Port Bind button Antenna BINDING Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code of a single specific transmitter. The DX3™ transmitter and SR315 receiver are bound at the factory.
EN TRANSMITTER PROGRAMMING End Point Adjustment Mode The default end point value is 100% for both steering and throttle/brake. The maximum end point value is 150% with adjustment. To adjust the endpoints of the steering and throttle/brake: 1. Power the transmitter on while holding the steering wheel full right and holding the trigger at full brake. The power LED flashes blue to indicate the transmitter is in end point adjustment mode. Steering: 2. Turn and hold the steering wheel full left.
EN 2.
EN merchandise until it arrives and is accepted at our facility. An Online Service Request is available at http://www. horizonhobby.com/content/service-center_render-servicecenter. If you do not have internet access, please contact Horizon Product Support to obtain a RMA number along with instructions for submitting your product for service. When calling Horizon, you will be asked to provide your complete name, street address, email address and phone number where you can be reached during business hours.
EN FCC INFORMATION Contains FCC ID: BRWKATY1T BRWSRIRVINGV1 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
© 2020 Horizon Hobby, LLC. DSM, DSM2, DSMR, DX3, AVC, Acitve Vehicle Control and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc. All other trademarks, service marks and logos are property of their respective owners. US 9,320,977. US 9,930,567. US 10,419,970. Created: 12/2019 SPM2340 60062.
