PowerSafe Telemetry Receiver Manual

EN
13
Hold
A Hold occurs when 45 consecutive frame losses occur. This takes about one
second, and in this event the receiver moves the channel outputs to the failsafe
settings. If a hold ever occurs, it’s important to re-evaluate the system and
check every component. If your system displays a hold taking place, diagnose
the cause and resolve the issue before flying again.
It is normal to see a hold logged if you power OFF your transmitter and back ON.
IMPORTANT: The Spektrum Flight Log (SPM9540) is not compatible with
the PowerSafe receivers.
Micro SD Card
When a micro SD card is inserted into the receiver, during operation, flight
information will be logged onto a file on the card including flight log data,
battery status and other telemetry data stored over time. If not deleted, older
data logs recorded will be deleted, keeping the most recent logs. This can be
a handy tool to review flight data over time which can be helpful for diagnosis
of performance.
Micro USB Updating
The PowerSafe receivers feature a Micro USB connector which can be used
with a micro USB cable (available separately) to update both the main receiver
firmware as well as any connected remotes making it very easy to update the
receiver and any attached remote receivers. Simply connect the receiver with a
micro USB cable and use the Spektrum PC programmer to update the receiver
and any attached remote receivers. Note: The Spektrum Programmer USB cable
must be disconnected from the computer for the micro USB connection to work.
Please make sure to use the Spektrum Programmer application v3.6 or newer.
Status LED
The Status LED will give information about the status of the receiver and give
warning codes if there is an issue or condition detected: Differentiate codes/
modes by flashing count. Note: Check the website for any future updates.
• White Blinking/Breathing - Initializing, not ready to fly
• Red - Failure, failure where you can't fly. Check power or RF.
• 2 blinks - 3S Power Detected/Protection engaged
• 1 blink - No remote detected in port A or not enough remotes detected,
need at least 2 remotes connected and one must be in port A.
• Solid Blue - Ready (w/ recording). Ready to fly recording w/ SD
• Solid Green - Ready (w/o recording). Ready to fly, not recording to an
SD card.