PowerSafe Telemetry Receiver Manual

To access channels above 12, you are required to enable X-Plus mode on your

transmitter. On DX18 transmitters, channels 11 and 12 will be locked at center if

X-Plus mode is not enabled.

To access 14 channel mode, you must select this option in compatible transmit-

ters.

NOTICE: When using X-Plus to get up to 20 channels, Channels 13-20

have 512ms resolution and a variable frame rate. They are intended for

auxilliary functions such as retracts, lights, etc. We do not recommend using

Channels 13-20 for ﬂight control surfaces. Note: If using 14 channel mode

in compatible transmitters, in 14 channel mode, all 14 channels are 22ms

at 2048 resolution and can be used for ﬂight control channels.

Note: Check your transmitter manual or receiver web site for compatibility

for 14 channel mode. 14 Channel mode is accessed through the Frame

Rate menu and will show in compatible transmitters. Transmitters may

need to be updated to add this feature if available.

See your Transmitter manual for more information about X-Plus mode

Getting Started

1. Install the receiver system in your aircraft.

2. Bind the receiver to your transmitter.

3. Complete model setup on your transmitter.

4. Conduct thorough ground testing.

5. Re-bind to set failsafe settings.

6. Range check.

7. Control surface check before ﬂying.

8. Unplug receiver battery(s) at the end of every ﬂying or testing session.

NOTICE: When using Y-harness or servo extensions with Spektrum

equipment, do not use reversing harnesses. Using reversing Y-harnesses or

servo extensions may cause servos to operate erratically or not function at all.