Instruction manual

15SPEKTRUM DX5e • RADIO USER’S GUIDE
EN DE FR IT
Federal Aviation Administration
Purpose
This advisory outlines safety standards for operations of
model aircraft. We encourage voluntary compliance
with these standards.
Background
Attention has been drawn to the increase in model aircraft
operation. There is a need for added caution when operating
free flight and radio controlled craft in order to avoid
creating a noise nuisance or a potential hazard to full-scale
aircraft and persons and/or property on the surface.
Operating Standards
Modelers generally are concerned with safety and exercise
good judgment when flying model aircraft. However, in
the interest of safer skies, we encourage operators of
radio controlled and free flight models to comply with the
following standards:
a. Exercise vigilance in locating full-scale aircraft (get help
if possible) so as not to create a collision hazard.
b. Select an operating site at sufficient distance from
populated areas so you do not create a noise problem or
a potential hazard.
c. Do not fly higher than 400 feet above the surface.
d. Always operate more than three miles from the
boundary of an airport unless you are given permission
to be closer by the appropriate air traffic control facility
in the case of an airport for which a control zone has
been designated or by the airport manager in the case of
other airports.
e. Do not hesitate to ask for assistance in complying with
these guidelines at the airport traffic control tower or
air route traffic control center nearest the site of your
proposed operation.
Information Provided By
Director, Air Traffic Service Federal Aviation Administration,
Washington, D.C.
Daily Flight Checks
1. Check the battery voltage on both the transmitter and
the receiver battery packs. Do not fly below 4.7V on the
transmitter or below 4.7V on the receiver. To do so can
crash your aircraft.
Note: When you check these batteries, ensure that
you have the polarities correct on your expanded scale
voltmeter.
2. Check all hardware (linkages, screws, nuts, and bolts)
prior to each day’s flight. Be sure that binding does not
occur and that all parts are properly secured.
3. Ensure that all surfaces are moving in the proper
manner.
4. Perform a ground range check before each day’s flying
session.
5. Prior to starting your aircraft, turn off your transmitter,
then turn it back on. Do this each time you start your
aircraft. If any critical switches are on without your
knowledge, the transmitter alarm will warn you at this
time.
6. Check that all trim levers are in the proper location.
7. All servo pigtails and switch harness plugs should
be secured in the receiver. Make sure that the switch
harness moves freely in both directions.
WARRANTY INFORMATION
Warranty Period
Exclusive Warranty- Horizon Hobby, Inc., (Horizon)
warranties that the Products purchased (the “Product”)
will be free from defects in materials and workmanship
for 1 year from the date of purchase by the Purchaser.
1-Year Limited Warranty
Horizon reserves the right to change or modify
this warranty without notice and disclaims all
other warranties, express or implied.
(a) This warranty is limited to the original Purchaser
(“Purchaser”) and is not transferable. REPAIR
OR REPLACEMENT AS PROVIDED UNDER THIS
WARRANTY IS THE EXCLUSIVE REMEDY OF THE
PURCHASER. This warranty covers only those
Products purchased from an authorized Horizon
dealer. Third party transactions are not covered by this
warranty. Proof of purchase is required for all warranty
claims.
(b)Limitations-HORIZONMAKESNOWARRANTYOR
REPRESENTATION, EXPRESS OR IMPLIED, ABOUT
NON-INFRINGEMENT, MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE OF THE PRODUCT.