Instruction manual

9SPEKTRUM DX5e • RADIO USER’S GUIDE

EN DE FR IT

BINDING

The AR600 receiver must be bound to the transmitter

before it will operate. Binding is the process of teaching the

receiver the speciﬁc code of the transmitter so it will only

connect to that speciﬁc transmitter.

Note: RTF aircraft and Radio Systems are pre-bound at

the factory. Rebinding is necessary if any settings are

changed to ensure proper failsafe settings are achieved.

1. To bind an AR600 to a DSM transmitter, insert the BIND/

DATA port in the charge plug receptacle.

Note: To bind an aircraft with an electronic speed

controller that powers the receiver through the throttle

channel (ESC/BEC), insert the bind plug into the BIND/

DATA port in the receiver and the throttle lead into the

throttle port. Proceed to Step #2.

2. Power the receiver by plugging in a receiver battery

in any port on the receiver. Note that the LED on

the receiver should be ﬂashing, indicating that the

receiver is in bind mode and ready to be bound to the

transmitter.

Shown above using a separate receiver pack

Note: When binding using a switch harness and

separate receiver pack, a three-wire switch harness

must be used such as SPM9530 (not shown). You may

need to purchase the Male/Female bind plug SPM6803

in addition to the switch harness.

Shown above using an ESC/BEC and a ight pack