Manual

32 SPEKTRUM DX6 • TRANSMITTER INSTRUCTION MANUAL

FUNCTION LIST



Custom Voice Setup

Use the custom voice setup function to set up custom voice alerts

ormessages.Forexample,withthecustomvoicesetupfunction

you can be alerted to a switch change report or a sequence of

alerts using the Stepping Events option. To add a new custom

voice alert or command, enter the Custom Voice Setup function

and select Add New Sound Event with the scroll wheel. Select

either Switch Change Report or Stepping Events.

Switch Change Report

Use this feature to have telemetry read in a certain switch

position, current switch position, or a variety of other alerts such

as“LandingFlaps”or“MixOn”.Beginbyselectingtheswitchyou

wish to use for the spoken alert, then select the desired setting

nexttoeachswitchposition.

Stepping Events

Stepping Events can be used to provide voice alerts when a switch

is moved, stepping through a list of events. Begin by selecting

the switch desired to trigger each step through the list (when the

switchistriggeredasselected,thesystemwillmovetothenext

item on the list going through the list of user-deﬁned selections

one by one.) Auto-Cycle can be selected to Inhibit or Active. If

inhibited, the system will go through the list 1 time only. If the

switch is triggered again when at the ﬁnal item in the list, it will

not begin at the top of the list. If Active, the system will restart at

thebeginningofthelistafterthelastitemonthelistwiththenext

switch trigger.

Steps are used to select the number of items on the list for the

system to call. This can be set from 0 to 16 so there can be up to

16itemscalledtothepilottriggeredbytheswitchselected.Next,

select the alert to be spoken for each stepped event on the list as

desired. A variety of alerts can be chosen from the list, including

telemetry alerts and a variety of ﬂight conditions and commands.



Telemetry

Telemetry is in both the system setup and the function list so you

can access the telemetry functions from either list.

You must power off the receiver and transmitter, then power them

bothontoresetthetelemetrydata.Youcanresetmin/maxvalues

by pressing the CLEAR button.

NEVER change Telemetry settings when the aircraft is powered

on.ThereisabriefinterruptioninRFoutputwhenexitingthe

Telemetry screen, and may cause a “Hold” condition.