Owner's manual

The Sub-Trim function of the DX2.0 is an electronic trimming feature that allows the neutral

position of the servo on either the steering or throttle channel to be moved, while allowing

the electronic trim lever for that channel to remain in the center position. This feature is very

useful, as it allows the servo arm/wheel position to be moved to help with control linkage

installation, eliminating the need to make mechanical linkage adjustments. Although the

Sub-Trim function is a very useful feature, it is suggested that only small amounts of sub-

trim be used so that no unwanted, non-equal servo travel is created. It is suggested that less

than 30 points of Sub-Trim be used during adjustment. If more than 30 points of Sub-Trim

are required, it is suggested that a mechanical linkage adjustment be performed.

Accessing the Sub-Trim Function

1. Turn on the transmitter power switch.

2. Press the SCROLL key to enter the Function Mode.

3. Press the SCROLL key until “TRIM” appears in small letters to the left of the screen.

4. Press the CHANNEL key to select the channel to be adjusted

(Steering, Throttle).

5. Press the INCREASE or DECREASE keys until the proper servo position is achieved.

6. Press the SCROLL key to access the Servo Reversing function.

7. To exit the Function Mode, either turn off the transmitter power switch or press the

SCROLL and CHANNEL keys at the same time.

Sub-Trim

(Function Mode)

Values: R/B 125 0 R/F 125

TRIM

stS

–

Indicates curent channel:

STS = Steering

THS = Throttle

Indicates current value