Owner manual
14 SPEKTRUM DX2S USER GUIDE
EN
REVERSE
The Reverse function (also known as servo reversing)
establishes the servo’s direction relative to the channel’s
input (e.g. a right steering input should result in a
right steering angle at the car). Reverse is available on
both channels and is normally the first function that is
checkedandadjustedduringprogramming.
TO ACCESS THE REVERSE FUNCTION
In the List screen use the Rolling Selector to highlight the
Reverse function.
PresstheRollingSelectortoaccesstheReversefunction.
The above screen will appear.
Use the Rolling Selector to place the box around the
desired channel that you wish to reverse.
ST = Steering
TH = Throttle
PresstheRollingSelectorandthesurroundingboxwill
flash. Use the Rolling Selector to select the desired servo
direction(REVorNOR).
To return to the Main screen press and hold the Rolling
Selector for more than three seconds.
SUB TRIM
The Sub Trim function is normally used to correct minor
angular inaccuracies that occur when placing the servo
horn on the servo. In many cases, the servo horn is
not exactly perpendicular to the servo (or in the exact
optimum desired position). Minor sub trim values can
be used to correct this offset inaccuracy. It’s important to
understand that large sub trim values can limit the total
throw of the servo in that direction, so small sub trim
values only are recommended.
TO ACCESS THE SUB TRIM FUNCTION
In the List screen use the Rolling Selector to highlight the
Sub Trim function.
PresstheRollingSelectortoaccesstheSubTrim
function. The Sub Trim screen shown above will appear.
Use the Rolling Selector to select the desired channel
you wish to reverse.
ST = Steering
TH = Throttle
PresstheRollingSelectortohighlightthatchannel
and the surrounding box will flash. Rotate the Rolling
Selectortoadjustthevalueanddirectionofthesubtrim.
To return to the main screen press and hold the Rolling
Selector for more than three seconds.