Owner manual
15SPEKTRUM DX2S USER GUIDE
EN
TIMER
The DX2S has three types of timers:
Internal timer - automatically records the time that the
transmitter is turned on.
Down timer – is the default (user selectable) timer type
that can be programmed for up to 60 minutes and 59
seconds in one-second increments. Normally this timer
is programmed for the length of a race and is defaulted to
5:00 minutes for electrics or the duration of the fuel tank
in gas, warning the driver that it’s time to pit. The Down
timer is started by pressing the timer button. When the
down timer expires, an alarm will sound until the timer
button is pressed. To pause or continue the Down timer,
press the timer button once. To reset the Down timer to
its preprogrammed value, press and hold the timer button
for more than 3 seconds.
Up timer - is started by pressing the timer button
and counts up from 00:00 seconds, functioning as a
stopwatch. The Up timer is useful for timing a fuel run to
determine fuel mileage/pit stop strategy or for electrics,
to time the run time of a pack to determine gear ratio and
setup information. To pause or restart the Up timer, press
thetimerbutton.ToresettheUPtimerto00:00pressand
hold the timer button for more than 3 seconds.
Either the Up or Down timer can be selected and
displayed.OnthemainscreenitisbelowtheInternal
timer.Onthetelemetryscreenitisbelowthemodel
number.
TO ACCESS THE TIMER FUNCTION
From the list screen rotate the Rolling Selector to
highlight the Timer function.
PresstheRollingSelectortoentertheTimer
function. The Timer screen will be displayed as shown
on this page.
Three primary timer functions are available.
Internal Timer Reset
To reset the internal timer, rotate the Rolling Selector and
place the box around “Inte Reset” then press the Rolling
Selector to reset the internal timer to 0:00:00.
Timer Reset
To reset the selectable timer, rotate the Rolling Selector,
place the box around “Timer Reset,” and press the
Rolling Selector.
Type
To select the timer type, rotate the Rolling Selector, place
the box around “Type” and press the Rolling Selector.
The surrounding box will flash. Rotate the Rolling
Selector to select the (Up or Down) timer type then press
the Rolling Selector to select.
With the down timer enabled, two additional parameters
(not found in the Up timer) are available.
Alarm:Toturnthealarmonoroff,rotatetheRolling
Selector,placetheboxaround“Alarm”andpressthe
Rolling Selector. The surrounding box will flash. Rotate
the Rolling Selector to select then press the Rolling
Selector.
Reset Value: To select the duration of the Down timer,
rotate the Rolling Selector and place the underscored line
beneaththeminuteorseconddigitstoadjustandpress
the Rolling Selector. The line should now flash. Rotate
the Rolling Selector to select the reset time value and
press the Rolling Selector to select.