NX8 Manual

35SPEKTRUM NX8 • TRANSMITTER INSTRUCTION MANUAL
EN
FUNCTION LIST
Switch Changes:
Use the switch change report to call out what your switch positions
are. With this menu you can assign audio reports for events such
as changing modes or rates, retract position, ap position, etc.
Stepping Reports:
Stepping reports let you select from a list of reports to announce
at each ip of a switch. Stepping reports move to the next report at
every ip of the switch.
Generic Reports:
Select Report At Power-Up and check off your desired switches to
get a switch position report of those switches when you power ON
the transmitter.
Center Tone:
This menu gives you the ability to add a tone at the center of each
stick travel.
Flight Modes:
Choose your audio reports to go with each ight mode in this menu.
Telemetry Warnings:
Shortcut to the Telemetry Warnings screen.
Trainer Alerts:
This menu gives the user the setup the type of audio alerts with trainer.
Model Start:
This menu gives you options for tones and voice for when your
model starts operation, based on throttle or a switch of your choice.
System Sounds:
Gives you control over the inactivity alarm and the low voltage alarm
Binding:
Gives you control over the audio events during the bind process.
For compatible video transmitters, this menu can select the options
directly from your NX8. Set the power level and frequency of your
video transmitter, and select SEND to make the change.
If you Bind a Forward Programming capable receiver to your
NX8, a Forward Programming menu will appear in the Function
List automatically. Think of the Forward Programming menu as
a programming interface for your connected receiver. The menu
structure, options and any changes made are done directly on
the receiver, the transmitter is only an interface. Each device may
have different menu structure and operate in a different manner
than the next Forward Programming device. The receiver must
be powered on and connected to be able to enter the forward
programming menu.
For compatible video transmitters, this menu can select the options
directly from your NX8. Set the Power level and frequency of your
video transmitter, and select Send to make the change.
VTX Setup
Forward Programming
Audio Events