NX8 Manual

48 SPEKTRUM NX8 • TRANSMITTER INSTRUCTION MANUAL

PHYSICAL TRANSMITTER ADJUSTMENTS

Adjust Stick Tension

Turn the screws clockwise a small amount using a small Phillips

screwdriver to tighten the stick tension and counter clockwise to

loosen.

NOTICE: Always do a test of stick tension while turning these

screws to ensure stick tension is not too loose or too tight.

Tightening a screw too much can damage a spring. Loosening a

screw too much can let a spring fall off and cause short-circuit

in the transmitter.

Control Stick Length Adjustment

1. Using a 2mm Allen wrench, turn the setscrew in the stick

counterclockwise to loosen it.

2. Make the stick shorter by turning it clockwise or longer

by turn ing it counterclockwise.

3. After adjustment of stick length, tighten the setscrew.

The NX8 has all the physical transmitter adjustments located around the gimbal face of each gimbal. This arrangement allows for quick

and easy adjustments with out taking the back cover off or removing any plugs to access adjustment screws.

Available adjustments:

Change the Throttle Ratchet

Change the Throttle Tension

Adjust Stick Tension

Vertical Tension

Horizontal Tension

Gimbal Travel Limit

Each gimbal has a switch at the top and bottom that can limit the

travel on that stick’s vertical movement.

Adjusting the gimbal travel limits

1. Remove the covers

2. Move the switches toward the center of the transmitter to use

the full travel available.

Move the switch to the outside of the case to reduce travel.

Gimbal Travel Limit Switches