User guide

Bracket adjusted for 50-size engineBracket adjusted for 90-size engine

• Plug the servo leads and rpm sensor into the appropriate ports in the receiver.

• You are now ready to bind the system.

Note: In order for the system to operate, one remote receiver must be plugged into

receiver port B or R.

Connections

The throttle and gear channels have two outputs. Output 1 is unregulated and the

pack voltage is provided at this port. Throttle and Gear outputs 2 are regulated to

5.2 volts when a throttle servo and gyro are used that are not compatible with high

voltage. Most gyros require less than 6 volts.

Binding Telemetry with PowerSafe Receivers

Spektrum PowerSafe receivers like the AR9110, AR12110 and the AR7110 require

a special binding procedure when using telemetry modules.

1. Insert a bind plug in the bind port in the receiver.

2. Insert the telemetry modules’ Data port lead into any un-used channel in the

receiver. (If all channels are being used remove any servo lead from the receiver

to allow an open servo port to be accessed).