User guide

18 19
EN
Modes of Operation
The RevLimit target rpm is adjusted thru the Gear channel (channel 5) output.
DX7
In system setup mode program AUX2 to GYRO and GEAR to AUX2, the RevLimit
will be controlled and adjusted via the AUX2 switch, and all the target rpm’s will be
adjusted using the GEAR channel travel adjust.
The Gyro Gain channel will plug into the AUX2 channel and the gyro screen will
be used to adjust the gyro gain (see the DX7 manual for more detail on gyro gain
settings).
In the travel adjust screen two values can be selected that will correspond with
the desired rpm. Note that two different rpms can be selected, or if one value is
programmed to zero, the RevLimit will be turned off when the AUX2 switch is in
that position.
IMPORTANT: When calibrating the system the AUX2 channel must remain at
100% in both directions.