Safety Instructions

EN
21
Problem Possible Cause Solution
Aircraft will not
respond to throttle
but responds to
other controls
Throttle not at idle
and/or throttle trim
too high
Reset controls with throttle
stick and throttle trim at lowest
setting
Throttle servo travel is
lower than 100%
Make sure throttle servo travel
is 100% or greater
Throttle channel is
reversed
(With battery disconnected from
aircraft) Reverse throttle channel
on transmitter
Motor disconnected
from ESC
Make sure motor is connected
to the ESC
Aircraft will not
Bind (during bind-
ing) to transmitter
Transmitter too near
aircraft during binding
process
Move powered transmitter a few
feet from aircraft, disconnect
and reconnect ight battery to
aircraft
Aircraft or transmitter
is too close to large
metal object, wireless
source or another
transmitter
Move aircraft and transmitter
to another location and attempt
binding again
The bind plug is not
installed correctly in
the bind port
Install bind plug in bind port
and bind the aircraft to the
transmitter
Flight battery/
transmitter battery
charge is too low
Replace/recharge batteries
Bind button not held
long enough during
bind process
Power off and repeat bind
process.
Troubleshooting Guide