Safety Instructions

EN
6
Programming the AR8360T receiver requires a Spektrum
™
DSM2
®
/DSMX
®
compatible transmitter with Forward Programming.
Transmitter and Receiver Binding
Binding
The AR8360T receiver must be bound to your transmitter before it will operate.
Binding is the process of teaching the receiver the specic code of the transmitter
so it will only connect to that specic transmitter.
1. Connect the optional SRXL2 remote receiver (SPM9747 or SPM4651T) if
desired and any telemetry sensors to the main receiver.
2. Push and hold the bind button on the receiver while turning the receiver on.
Release the bind button once
the orange LED starts
to ash continuously,
indicating the receiver
is in bind mode.
TIP: It is still possible to
use a bind plug in the
bind port if desired. This can
come in handy if the receiver needs
to be mounted in a location that is difcult
to access, in which case a servo extension may
be used for binding. If using a bind plug, remove after
binding to prevent the system from entering bind mode
the next time the power is turned on.
3. Put your transmitter in bind mode.
4. The bind process is complete when the orange LED on the receiver is solid.
ANTENNA INSTALLATION
The AR8360T receiver has coaxial style
antennas. We recommend installing the
antennas oriented 90º from each other and as
far as possible from metal, batteries, carbon
ber or fuel tanks to maximize signal reception
performance.
NOTICE: Do not cut, kink, or modify the antennas. Damage to the coaxial
portion of an antenna will reduce the performance of the antenna.
Shortening or cutting off the 31mm tip will reduce the range.
Active portion
of antenna