Safety Instructions

AS3X Reaction Test

This test ensures that the AS3X control system is functioning properly.

1. Assemble the aircraft, bind your transmitter to the receiver, and complete the

AS3X First Time Setup in the Forward Programming menu before performing

this test.

2. Raise the throttle above 25% to activate AS3X, then lower the throttle. Once

the AS3X system is active, control surfaces move in response to aircraft

movement. AS3X remains active until the battery is disconnected.

CAUTION: Activate throttle cut to prevent motor operation during

this test.

3. Move the aircraft as shown and ensure the control surfaces move in the

direction indicated in the graphic. If the control surfaces do not respond as

shown, do not y the aircraft.

Aircraft Movement Control Surface Reaction

RudderElevator

Aileron

4. If the control surfaces do not respond as shown, review the receiver

mounting orientation.

1. In your transmitter’s menu select

Forward Programming -> Gyro Settings -> System Setup -> Orientation

2. Verify the receiver orientation matches the selected diagram. The image

of the airplane is from the top. If your access to the receiver is from the

bottom, remember the images on the screen need to match the way the

receiver sits in the model when it is upright.