User Manual

EN
5
Standard Mode
If loss of signal occurs, SmartSafe™
technology moves the throttle channel
to its designated failsafe position (low
throttle) that was set during binding.
All other channels hold their last
position. When the receiver detects
signal from the transmitter, normal
operation resumes.
Gas Mode
Preset failsafe is ideal for most nitro/
gas vehicles. With preset failsafe,
all channels go to their preset
failsafe positions if the signal is lost,
preventing an out of control situation.
When the receiver detects signal
from the transmitter, normal operation
resumes.
Testing Failsafe
Secure the vehicle with the wheels off the ground. Test Failsafe by turning the
transmitter off and noting how the receiver responds.
Gas Mode
1 Push and Hold Bind Button
2 Power on Reciever, keep Bind button depressed until binding is complete
3 Place transmitter in Bind Mode and fi nish Binding.
4 When the LED turns solid, power off the reicever, and then release the Bind Button
Standard Mode
1 Push and Hold Bind Button
2 Power on Reciever
3 Release Button after RX goes into Bind Mode (fl ashing LED)
4 Place transmitter in Bind Mode and fi nish Binding.
Binding
The SR215, SR315 and SR515 receivers must be bound to the transmitter
before they will operate. Binding is the process of teaching the receiver
the specifi c code of the transmitter so it will only connect to that specifi c
transmitter.
Failsafe
Failsafe position is set during binding. In the unlikely event that the radio link
is lost during use, the receiver will drive all channels to its pre-programmed
failsafe position.
Bind Button