User Manual

17Creon
Source 1: Jack
Connect here signal sources with balanced connections, for example, a DA converter.
If you only connect the left channel, the signal is automatically placed as mono in the
monitoring path (in the center of the stereo image).
Specications:
1/4“ jack, balanced
(Sleeve=Ground, Tip=hot, Ring=cold
Input impedance: 10kOhm unbalanced, 20kOhm balanced
Maximum input level +22.5 dBu.
Frequency Response: 10Hz - ›200kHz
Noise: -95 dBu (unweighted, unity gain, input termination 600 Ohm)
Common Mode Rejection ratio: ‹ -60 dBu
THD+N Ratio: 0,002% (at 1kHz, unity gain, input termination 600 Ohm)
Connections
Content