User Manual

20Creon

XLR Sockets

The image below shows the XLR connectors

pinout. They are balanced and have three con-

ductors or wires. Conductor 2 (Pin 2) corres-

ponds to the (+) or hot Signal. The diagram also

shows how to wire the balanced XLR connec-

tions if unbalanced connections are required,

for example to RCA or TS inputs and outputs

Mic Inputs

You can connect dynamic, condenser, tube, and ribbon microphones to the mic inputs.

Use the Phantom switch to provide phantom power to the microphones that require it.

For more information, read the „48 V“ section on page 28.

Specications: XLR connectors

Input impedance 10 kOhm

Maximum input level +14.5 dBu (Gain knob hard left).

Frequency Response: 10 Hz - ›200 kHz

Noise: -90 dBu (unweighted, 30dB gain, input termination 150 Ohm)

Equivalent Input Noise: -128 dBu

Common Mode Rejection Ratio: ‹ -70 dBu

THD+N Ratio: 0,003 % (at 1 kHz, 30 dB gain, input termination 150 Ohm)

Input

Output

balanced

unbalanced

balanced

unbalanced

1=GND

2=hot (+)

3=cold (-)

Connections

Content