User Manual

23Creon
Phones
Use the Phones jack on the front panel to connect your headphones. You can connect
all types of headphones with impedances from 20 to 600 Ohm. This wide range entails
big volume differences between low- and high-impedance headphones. In order to
keep under control low impedance headphones, we set a comparatively high impe-
dance of 33 Ohms at the output.
Specications:
1/4“ stereo jacks
(Sleeve=Ground, Tip=left channel, Ring=right channel)
Output impedance 33 Ohm
Frequency Response: 10Hz - >200kHz
IMPORTANT:
When connecting them, make sure that the plug
is completely in and that is rmly attached.
Power at 0 dBu:
47 Ohm load: 13 mW
300 Ohm load: 1,7 mW
600 Ohm load: 1,0 mW
Power max.:
47 Ohm load: 670 mW
300 Ohm load: 265 mW
600 Ohm load: 150 mW
THD+N Ratio (at 1 kHz, Power at 0dBu)
47 Ohm: 0,0026 %
300 & 600 Ohm: 0,002 %
Connections
Content