Use and Care Manual

SSGSB99 Single Stage Gas Snow Blower Instruction Manual
8
Figure 14
Figure 13
Spark Plug Gap: 0.6 ~ 0.8mm (0.0236 inch ~ 0.0314961 inch)
Spark Plug Torque: 11 ~ 13N.m
Replacement : A5RTC / Champion Z9Y
Engaging the Rotor Blades Disengaging the Rotor Blades
To engage the rotor blades, hold the Control To disengage the rotor blades, release
Bar against the handle (figure 13). the Control Bar (figure 14).
Prevent Freeze-Up After Use
Let the engine run for a few minutes to prevent moving parts from freezing. Stop the engine, wait for all moving parts to stop, and remove ice and
snow from the machine. Clean off any snow and ice from the base of the chute. Rotate the discharge chute left and right to free it from any ice
buildup. With the ignition key removed, pull the recoil starter handle several times or connect the electrical cord to a power source and the machine
and push the electric start button once to prevent the recoil starter and/or the electric starter from freezing up. In snowy and cold conditions, some
controls and moving parts may freeze. Do not use excessive force when trying to operate frozen controls. If you have difficulty operating any control
or part, start the engine and let it run for a few minutes.
SPARK PLUG SPECIFICATIONS