Use and Care Manual

Cleaning the Dust Filter

1. Disconnect the power supply.

2. Push down on the two handles of the filter and pull outwards. (Fig 2)

3. Clean under lukewarm water and mild detergent.

4. Make sure filter is completely dry before operating unit.

Cleaning the Water Curtain

1. Disconnect the power supply.

2. Remove the 3 screws located on the back frame: one in each top corner and

one at bottom center. Do not remove back panel yet.

3. Panel is connected to the unit by a water tube, gently remove end of tube

that is connected to the water pump. (Fig. 3) Remove back panel.

4. Remove water curtain by first removing the bottom rod – push in gently.

Then remove from top rod by separating the Velcro attachment.

5. Wash water curtain in a mild detergent and warm water solution, then rinse

in clean water. (Fig. 4)

6. Replace water curtain; make sure tube is firmly connected to the pump.

Storage

If you plan not to use the unit for a long period of time, drain the water tank and

wipe clean. Clean the filter and water curtain. Operate the unit in normal fan

mode for approximately 30~60 minutes on a sunny day. This will dry the interior

and prevent mold from growing. It is recommended to pack the unit in its original

box and store in a dry, cool place

F. CAUTIONS

(Fig. 5) (Fig. 6) (Fig. 7)

1. Use normal supply of 120V / 60Hz. Plug into dedicated socket with minimum

rating current of 3A.