User Manual

16
REPLACING THE BATTERY
The light turns on to indicate that the batteries are drained
.
The remote control is powered by a lithium button battery
CR2450. To replace the battery :
1. Use small pliers to remove the foam protecting the screws
at the back of the remote.
2. Unscrew the 6 screws.
3. Open the cover and take out the battery. Dispose of
properly.
4. Install the new battery in as indicated. Battery polarity must be respected.
5. Close the cover, put the screws and the foams back.
The camera and the remote control will remain synchronized.
ATTACHING THE REMOTE CONTROL
To attach the remote control using the strap (included),
just insert the strap into the slots on each side of the back
of the remote.
4x
3x
2x
1x
Remote control • XCEL HD2