User Manual
19
STORAGE
If the camera will not be used for an extended period, the camera should be
stored properly. Remove the lithium-ion polymer battery from the camera
before storing it. The storage temperature should be between -40 °C and +
60 °C (-40 °F and +140 °F). Lithium-ion polymer battery should be stored
at around 50% state-of-charge.
CLEANING THE LENS
Install the lens protector (included) on the lens of the camera when it is
used without the waterproof housing. To clean the lens, use an air blower
to remove dirt such as dust or sand. Then gently wipe the lens tissue
(included) on the lens.
CLEANING THE CAMERA
Gently wipe the camera with a soft, dry cloth. DO NOT use thinners or other
cleaners to clean the camera, these products can cause damage.
CLEANING THE WATERPROOF HOUSING
It is important that the rubber gasket is always clean to ensure a
perfect seal. Rinse the housing in fresh water and shake it to dry. Do not
use a cloth to dry the seal, as lint may settle there and compromise the
eectiveness of it. After the use of the housing in salt water, rinse it in fresh
water and dry it. The salt can build up on the seal and the buttons may rust.
Note: It is important to follow these tips, because the warranty does
not cover any GG Telecom products which has been subjected to water
damage due to user error.
WARNINGS
• Never place the camera or the battery inside or above a heating device
such as a microwave oven, a stove or a radiator. This could lead to over-
heating or the deformity of materials, or even cause a re or explosion.
• Protect the lens from ngerprints and scratches using the lens protector
or waterproof housing.
• Do not expose the memory card to extreme temperatures (below -20
°C or above 50 °C). This may cause the memory cards to malfunction.
• Insert the memory card in the correct direction, otherwise it may
damage the camera and the memory card.
• Do not bend, drop or subject the memory card to shock or pressure.
• Do not put the memory card into contact with liquids, dust or foreign
bodies. If the memory card is dirty, clean with a soft cloth before you
insert it into the camera.
• Do not place the camera on ammable surfaces such as bedding,
blankets, carpets, or electric blankets for extended periods.
• Use only replacement lithium-ion battery XHD-BATT (sold separately,
see AVAILABLE ACCESSORIES section).
• Cold temperatures can aect battery life.
• The recommended operating temprature is between -30 °C to + 50 °C
(-22 °F to +122 °F)
Maintenance of the camera