Installation Manual

31169-601-01

10/2006

Lexington, KY, USA

Instruction Bulletin

Square D

Intelligent Load Center

Indoor Load Centers, Class 1130

Retain for future use.

Introduction

This bulletin contains instructions for the installation and operation of

indoor load centers.

Safety Precautions

Preparation

1. Determine the wiring or conduit requirements for the main and

branch circuits, as required by local electrical codes.

2. Select the proper cable clamp, or use other approved methods for

securing the cable or conduit to the enclosure.

3. Remove the appropriate knockouts required for installation of cable

clamps or conduit. To remove the knockouts, see Figure 1 on

page 2.

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

• Apply appropriate personal protective equipment (PPE) and follow safe electrical

work practices. See NFPA 70E.

• This equipment must only be installed and serviced by qualified electrical

personnel.

• Turn off all power supplying this equipment before working on or inside equipment.

• Always use a properly rated voltage sensing device to confirm power is off.

• Replace all devices, doors and covers before turning on power to this equipment.

• Do not allow petroleum-based paints, solvents, or sprays to contact the nonmetallic

parts of this product.

• Before starting a wiring installation or addition, consult a local building or electrical

inspector for current National Electrical Code requirements. Local codes vary, but

are adopted and enforced to promote safe electrical installations. A permit may be

needed to do electrical work, and some codes may require an inspection of the

electrical work.

• This equipment may not be suitable for use in corrosive environments present in

agricultural buildings. See NEC 547 or CEC 2–400.

Failure to follow this instruction will result in death or serious injury.

ENGLISH