Installation Manual

© 2006 Schneider Electric USA All Rights Reserved
Square D
®
Intelligent Load Center 31169-601-01
Enclosure Mounting 10/2006
2
ENGLISH
Enclosure Mounting
NOTE: When mounting the enclosure, be sure to locate it near the
generator location and gas lines.
Surface Mounting
Fasten the enclosure to the wall with screws or nails. Use all of the
pre-cut holes in the back of the enclosure. See Figure 2.
Flush Mounting
1. Remove the small mounting knockouts on the side of the enclosure.
See Figure 2.
2. Position the load center so the front edge of the enclosure is flush
with the finished wall.
3. Nail or screw through the small knockouts on the enclosure sides.
See Figure 2.
Figure 1: Removing the Knockouts
Figure 2: Mounting the Enclosure
Surface Mounting
Flush Mounting